OBD-II Trouble Code Technical Description
Article by
Stephen Darby
ASE Certified Technician
Reductant Tank Temperature Sensor Circuit Range/Performance
What does that mean?
This diagnostic trouble code (DTC) is a generic powertrain code and applies to many OBD-II vehicles (1996-newer). That may include but is not limited to vehicles from Mercedes, Sprinter, Ford, GMC, Chevrolet, etc. Although generic, the exact repair steps may vary depending on year, make, model and powertrain configuration.
A stored code P205B means that the powertrain control module (PCM) has detected an abnormal degree of voltage in the reductant tank temperature sensor circuit. This code is exhibited in vehicles with a clean burning diesel engine, exclusively.
The catalyst system is responsible for reduction of (basically) all exhaust emissions although certain applications are also equipped with a NOx trap.
Exhaust gas recirculation (EGR) systems go another step further in the reduction of NOx. Nevertheless, today's larger and more powerful diesel engines cannot meet strict federal (U.S.) emission standards with the EGR, diesel particulate filter/catalytic converter, and NOx trap alone. It was for this reason that selective catalytic reduction (SCR) systems were invented.
SCR systems inject a reductant compound or a diesel exhaust fluid (DEF) into the exhaust in front of the diesel particulate filter, NOx trap, and/or the catalytic converter via the reductant injection valve (solenoid). The precisely timed DEF injection elevates the temperature of the filtration element and allows it to perform more efficiently. It enhances filtration element longevity and allows fewer harmful exhaust emissions to be released into the atmosphere. The entire SCR system is monitored and controlled by either the PCM or a stand-alone controller (which interacts with the PCM). Either way, the controller monitors the O2, NOx, and exhaust temperature sensors (as well as other inputs) to determine the appropriate time for DEF (reductant) injection. Precise DEF injection is necessary to maintain exhaust temperature within acceptable parameters and optimize pollutant filtration.
The reductant/regeneration supply pump is used to pressurize the DEF in the liquid reductant system for use, when required. Supply pump voltage is monitored by the PCM for consistent fluctuation and load percentage. The PCM also monitors one or more pressure sensors in the reductant supply system to determine if there is a leak in the system.
If the PCM detects a degree of voltage in the reductant tank temperature sensor circuit that is not within acceptable parameters, a code P205B will be stored and a malfunction indicator lamp (MIL) may be illuminated. Multiple ignition cycles - with a failure - may be required for MIL illumination.
Example of a DEF reductant tank:
What is the severity of this DTC?
A stored code P205B should be considered severe and addressed as quickly as possible. The SCR system could be disabled because of it. Catalyst damage could result if the conditions which contributed to the code being stored are not rectified in a timely fashion.
What are some of the symptoms of the code?
Symptoms of a P205B trouble code may include:
- Reduction in fuel efficiency
- Excessive black smoke from vehicle exhaust
- Diminished engine performance
- Other SCR related codes
What are some of the common causes of the code?
Causes for this code may include:
- Defective reductant tank temperature sensor
- Open or shorted circuits in the reductant tank temperature sensor system
- Bad SCR controller/PCM or programming error
What are some P205B troubleshooting steps?
A diagnostic scanner, a digital volt/ohmmeter (DVOM), and a source of vehicle specific diagnostic information will be required to diagnose a code P205B.
You may use your source of vehicle information to locate a technical service bulletin (TSB) that matches the vehicle year, make, and model; as well as the engine size, code/s stored, and symptoms exhibited. If you find one, it could yield helpful diagnostic information.
Use the scanner (connected to the vehicle diagnostic connector) to retrieve all stored codes and pertinent freeze frame data. It is a good idea to write this information down before clearing the codes then test-drive the vehicle until the PCM either enters readiness mode or the code is reset.
If the PCM enters readiness mode at this time, the code is intermittent and may be much more difficult to diagnose. If this is the case, the conditions which contributed to the code being stored may need to worsen before an accurate diagnosis can be made.
If the code is immediately reset, the next step of your diagnosis will require that you search your vehicle information source for diagnostic flow-charts, connector pin-out charts, connector face views, and component testing procedures/specifications.
Step 1
Use the DVOM to test the reductant temperature sensor according to manufacturer specifications. Components which do not test within maximum allowable parameters should be considered defective.
Step 2
If actual reductant temperature is within specifications, the code P205B persists, and the sensor in question is in working order, use the DVOM to test input and output signal circuits between the temperature sensor and the PCM/SCR controller. Disconnect all controllers prior to using the DVOM for testing.
- Reductant temperature sensor codes are usually attributed to a defective or disconnected sensor
Related DTC Discussions
Register now to ask a question (free)
- 2011 GMC Sierra 2500 Diesel was P205B now P203C code
First I have a 2011 GMC Sierra 2500 DieselI originally received P205B so I replaced part 20760381 with Dorman 904-371 Diesel Emissions Fluid Temperature Sensor.Now I am getting P203C. I am having trouble locating what part I need to replace to fix that. I think it is the DEF Pump/Heater (2337934... - P205B reductant tank temperature sensor circuit range performance
I replaced the DEF heater. I still can not clear the code. Though what check engine light turns off on the - however when you search for codes it pops backup but does not eliminate on the dash unless I drive it for 50 miles then it will re luminate on the dash. Looking for some direction. The de...
Need more help with a P205B code?
If you still need help regarding the P205B trouble code, please postyour question in our FREE car repair forums.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
NOTE: This information is presented for information purposes only.It is not intended as repair advice and we are not responsible for any actionsyou take on any vehicle. All information on this site is copyright protected.
